ROLLUP Banner Film
8mil 100% polyester film offering
Anti-Curl, Block-out and a Satin Print Surface for Retractable Banner Stands
and Tradeshow Displays.
Key Features & Benefits
Properties:
The product offers a satin print
surface resulting in saturated color for images and graphics while holding
fine details and type. Trims clean and even with straight edge and blade. No
warping, buckling or stretching under normal conditions.
Longevity: Interior Roll-up stands. Exterior
transit shelters and Plexi-glass protected sign frames.
Handling: Avoid touching material on print face
which can cause finger prints when printed. An external dryer or heat lamp
will accelerate drying. If required, additional out-gassing of inks can be
achieved by standing a loosely wound roll on end for a period of time.
Printing:
4 color black generation is not
recommend. For best results maximum ink load is 250%. Latex Printers:
Media choice “Film”. Rip setting:
media choice “HP White Satin Poster
Paper”.
Extreme heat can cause
material to buckle. For best results calibrate media feed and bi-directional
printing before using. 720 dpi, 8 pass offers a good balance between quality
and speed.
Post Printing: Allow up to 24 hours before
laminating. PSA laminates are recommended but not required for retractable
displays. For pop-up tradeshow booths use 5-10mil semi-rigid laminate.
Installation:
Trim
to recommended size according to display unit. Note: most units require up
to 6 inches of extra material at the bottom graphic. Clip hanger bar to top
of graphic and apply adhesive backed Velcro to bottom and mount to leader
material extending out of display unit. While holding graphic pull tension
pin and slowly lower graphic into stand.